Terminalserver(config)#menu cisco clear-screen In order to clear the screen after it enters the menu, this command is used. Terminalserver(config)#menu cisco text 2 login to R2 Terminalserver(config)#menu cisco command 2 resume R2 / connect telnet R2 This menu command opens a new connection or resumes the connection that exists to the configured host. Terminalserver(config)#menu cisco text 1 login to R1 Terminalserver(config)#menu cisco command 1 telnet 10.1.1.1 2003 In order to setup a new connection, these menu commands are used. Terminalserver(config)#menu cisco line-mode Menu runs directly after the selection an option, if you don't use this command. You have to configure line-mode to enforce the need to hit Enter after you select an option. Terminalserver(config)#menu cisco prompt $ This command needs to be configured to as it gives the options to make selections in a Menu. To exit from the device, use CTRL+SHIFT+6 then press x In order to configure menu options, you can first configure a banner or title for the terminal server as shown in this example: Terminalserver(config)#menu cisco title $Įnter TEXT message. Port number for connecting to the device is 2004 (2000+4). For example, line number for a device connected to port 0/0/1 is 4 as you can see in the preceding output. Port numbers can be obtained by adding 2000 to the line number corresponds to each device. Configure IP host mappings for each device as in below example. Tty Line Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int HWIC-8A provides 8 lines as you can see in the output. Check the physical connections from the terminal server to the end devices and make a note of line number corresponds to each device. Terminalserver(config)#interface loopback 1 Configure a loopback interface on the Router and assign IP address to the same. If your network is live, make sure that you understand the potential impact of any command. All of the devices used in this document started with a cleared (default) configuration. The information in this document was created from the devices in a specific lab environment. The information in this document is based on Integrated Service Routers Generation 2 (ISR G2) with an Async module like HWIC-8A. Prerequisites RequirementsĬisco recommends that you have knowledge of these topics: This document describes the configuration of a Cisco Router as a terminal server and their usage of Menu options to manage the access of devices connected to the terminal server.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |